CPCISA - Revision history

Phi2x at 13:45, 8 May 2024

2024-05-08T13:45:33Z

Phi2x at 15:51, 15 April 2024

2024-04-15T15:51:42Z

Polluks: /* Status */ typo

2023-06-06T23:45:43Z

‎Status: typo

OffseT: Created page with "Category:Peripherals Prototype of the CPCISA card === What it is === CPCISA is a project created by Siou, also hosted/worked on at..."

2022-09-10T08:19:11Z

Created page with "Category:Peripherals Prototype of the CPCISA card === What it is === CPCISA is a project created by Siou, also hosted/worked on at..."

New page

[[Category:Peripherals]]
[[Image:Cpcisa2b.jpg|200px|thumb|Prototype of the CPCISA card]]

=== What it is ===

CPCISA is a project created by [[Siou]], also hosted/worked on at [[Yarek]].

Basically, it is a hardware add-on that lets you connect ISA cards to your old CPC! Some examples of what it can offer:
*An I/O interface (Serial and parallel ports, Floppy and IDE ports)
*An internal (card) modem (probably a full-featured modem is needed; that is, not a winmodem/softmodem)
*A SoundBlaster card (or 100% compatible)
*A network card

ISA cards were almost fully supported, including 16-bit mode and vectorized interrupts(thru Z80 IM2). Only video cards were not supported (CPCISA decodes only I/O ports, not memory mapped VRAM).

=== Status ===

The card is working, however only five of them were built (including the initial dev board). This is because the card was complex and outdated, ISA peripherals and the AT standard became old and difficult to find.

Most CPCISA softwares were created by Siou himself (IDE hard disk, ethernet and mouse drivers, as well a an audio sample player thru SoundBlaster 8-bit interface). Initial OS support was done by [[Futur's]] with a set of two ROMs ("Interrupt Lib" ROM to add vectorized interrupt support to Locomotive Firmware, and "ISA ROM" with low level ISA routines). [[Madram]] also created an Adlib music player supporting SA2 module files, which was later adapted by [[PulkoMandy]] to play these modules with the [[Willy]] card equipped with a OPL3LPT device.

It was mostly a proof of concept; none of the drivers and software came to a state really usable for the end user (no filesystem support, no TCP/IP stack...).

=== Additional info ===
*[http://siou.free.fr/General/Pages/index-cpc6128.html Siou's page on CPCISA]. Siou is the creator of the system.
*[http://futurs.chez.com/FElectro.html Some more information about CPCISA from Futurs' website (French)]
*[http://futurs.chez.com/FTelecharge.html Where to download and get information about "Interrupt Lib" and "ISA ROM" from Futurs' website (French).]
*[http://8bit.yarek.pl/interface/cpc.cpcisa/index.html Yarek's CPCISA page] about making a CPC-Isa compatible system which would connect to a full 286 AT PC motherboard.

← Older revision		Revision as of 15:51, 15 April 2024
Line 21:		Line 21:

	It was mostly a proof of concept; none of the drivers and software came to a state really usable for the end user (no filesystem support, no TCP/IP stack...).		It was mostly a proof of concept; none of the drivers and software came to a state really usable for the end user (no filesystem support, no TCP/IP stack...).
		+
		+	== CPCISA ports for ISA cards ==
		+
		+	{\|{{Prettytable\|width: 700px; font-size: 2em;}}
		+	\|''Device''\|\|''PC I/O range''\|\|''CPCISA high''\|\|''CPCISA low''
		+	\|-
		+	\|IDE1\|\|1F0h..1F7h\|\|#FDF0..#FDF7\|\|#FFF0..#FFF7
		+	\|-
		+	\|IDE2\|\|170h..177h\|\|#FD70..#FD77\|\|#FF70..#FF77
		+	\|-
		+	\|Joystick\|\|201h..201h\|\|#FC01..#FC01\|\|#FE01..#FE01
		+	\|-
		+	\|Ethernet\|\|210h..21Fh\|\|#FC10..#FC1F\|\|#FE10..#FE1F
		+	\|-
		+	\|Sound Blaster\|\|220h..23Fh\|\|#FC20..#FC3F\|\|#FE20..#FE3F
		+	\|-
		+	\|LPT2\|\|278h..27Fh\|\|#FC78..#FC7F\|\|#FE78..#FE7F
		+	\|-
		+	\|COM1\|\|2F8h..2FFh\|\|#FCF8..#FCFF\|\|#FEF8..#FEFF
		+	\|-
		+	\|MIDI'\|\|300h..301h\|\|#FD00..#FD01\|\|#FF00..#FF01
		+	\|-
		+	\|MIDI\|\|330h..331h\|\|#FD30..#FD31\|\|#FF30..#FF31
		+	\|-
		+	\|Sound control\|\|370h..371h\|\|#FD70..#FD71\|\|#FF70..#FF71
		+	\|-
		+	\|FDC1\|\|372h..377h\|\|#FD72..#FD77\|\|#FF72..#FF77
		+	\|-
		+	\|LPT1\|\|378h..37Fh\|\|#FD78..#FD7F\|\|#FF78..#FF7F
		+	\|-
		+	\|Sound AD-LIB\|\|388h..38Bh\|\|#FD88..#FD8B\|\|#FF88..#FF8B
		+	\|-
		+	\|VGA\|\|3B0h..3BBh\|\|#FDB0..#FDBB\|\|#FFB0..#FFBB
		+	\|-
		+	\|LPT3\|\|3BCh..3BFh\|\|#FDBC..#FDBF\|\|#FFBC..#FFBF
		+	\|-
		+	\|VGA\|\|3C0h..3DFh\|\|#FDC0..#FDCF\|\|#FFC0..#FFCF
		+	\|-
		+	\|FDC1\|\|3F2h..3F7h\|\|#FDF2..#FDF7\|\|#FFF2..#FFF7
		+	\|-
		+	\|COM1\|\|3F8h..3FFh\|\|#FDF8..#FDFF\|\|#FFF8..#FFFF
		+	\|-
		+	\|}
		+
		+	== CPCISA ports for ISA motherboard ==
		+
		+	{\|{{Prettytable\|width: 700px; font-size: 2em;}}
		+	\|''Device''\|\|''PC I/O range''\|\|''CPCISA high''\|\|''CPCISA low''
		+	\|-
		+	\|DMA\|\|000h..00Fh\|\|#FC00..#FC0F\|\|#FE00..#FE0F
		+	\|-
		+	\|interrupt\|\|020h..03Fh\|\|#FC20..#FC3F\|\|#FE20..#FE3F
		+	\|-
		+	\|counter\|\|040h..05Fh\|\|#FC40..#FC5F\|\|#FE40..#FE5F
		+	\|-
		+	\|keyboard\|\|060h..067h\|\|#FC60..#FC67\|\|#FE60..#FE67
		+	\|-
		+	\|RTC\|\|070h..071h\|\|#FC70..#FC71\|\|#FE70..#FE71
		+	\|-
		+	\|DMA\|\|080h..08Fh\|\|#FC80..#FC8F\|\|#FE80..#FE8F
		+	\|-
		+	\|DMA\|\|0C0h..0DFh\|\|#FCC0..#FCDF\|\|#FEC0..#FEDF
		+	\|-
		+	\|interrupt\|\|0A0h..0BFh\|\|#FCA0..#FCBF\|\|#FEA0..#FEBF
		+	\|-
		+	\|}

	=== Additional info ===		=== Additional info ===

@@ Line 2: / Line 2: @@
 [[Image:Cpcisa2b.jpg|200px|thumb|Prototype of the CPCISA card]]
-=== What it is ===
+== What it is ==
 CPCISA is a project created by [[Siou]], also hosted/worked on at [[Yarek]].
@@ Line 14: / Line 14: @@
 ISA cards were almost fully supported, including 16-bit mode and vectorized interrupts(thru Z80 IM2). Only video cards were not supported (CPCISA decodes only I/O ports, not memory mapped VRAM).
-=== Status ===
+== Status ==
 The card is working, however only five of them were built (including the initial dev board). This is because the card was complex and outdated, ISA peripherals and the AT standard became old and difficult to find.
@@ Line 88: / Line 88: @@
 |}
-=== Additional info ===
+== Additional info ==
 *[http://siou.free.fr/General/Pages/index-cpc6128.html Siou's page on CPCISA]. Siou is the creator of the system.
 *[http://futurs.chez.com/FElectro.html Some more information about CPCISA from Futurs' website (French)]
 *[http://futurs.chez.com/FTelecharge.html Where to download and get information about "Interrupt Lib" and "ISA ROM" from Futurs' website (French).]
 *[http://8bit.yarek.pl/interface/cpc.cpcisa/index.html Yarek's CPCISA page] about making a CPC-Isa compatible system which would connect to a full 286 AT PC motherboard.

@@ Line 18: / Line 18: @@
 The card is working, however only five of them were built (including the initial dev board). This is because the card was complex and outdated, ISA peripherals and the AT standard became old and difficult to find.
-Most CPCISA softwares were created by Siou himself (IDE hard disk, ethernet and mouse drivers, as well a an audio sample player thru SoundBlaster 8-bit interface). Initial OS support was done by [[Futur's]] with a set of two ROMs ("Interrupt Lib" ROM to add vectorized interrupt support to Locomotive Firmware, and "ISA ROM" with low level ISA routines). [[Madram]] also created an Adlib music player supporting SA2 module files, which was later adapted by [[PulkoMandy]] to play these modules with the [[Willy]] card equipped with a OPL3LPT device.
+Most CPCISA software were created by Siou himself (IDE hard disk, ethernet and mouse drivers, as well a an audio sample player thru SoundBlaster 8-bit interface). Initial OS support was done by [[Futur's]] with a set of two ROMs ("Interrupt Lib" ROM to add vectorized interrupt support to Locomotive Firmware, and "ISA ROM" with low level ISA routines). [[Madram]] also created an Adlib music player supporting SA2 module files, which was later adapted by [[PulkoMandy]] to play these modules with the [[Willy]] card equipped with a OPL3LPT device.
 It was mostly a proof of concept; none of the drivers and software came to a state really usable for the end user (no filesystem support, no TCP/IP stack...).